Tying a ribbon on a field is a straightforward but elegant means so as to add a contact of sophistication to any present. Whether or not you are wrapping a gift for a special day or simply wish to make your packaging look extra polished, a ribbon may help you obtain the right final touch. On this article, we’ll give you a step-by-step information on how you can tie a ribbon on a field, together with some ideas and tips for getting the right bow.
Earlier than you begin, you will want to assemble your supplies. You may want a ribbon, in fact, in addition to a pair of scissors and a tape measure or ruler. When you’re utilizing a very slippery ribbon, you might also wish to use a little bit of double-sided tape to assist maintain it in place. After you have your supplies, you are prepared to start out tying!
To tie a ribbon on a field, begin by measuring the ribbon across the field. You may need the ribbon to be lengthy sufficient to wrap across the field twice, with sufficient left over to tie a bow. After you have the ribbon measured, reduce it to the specified size. Subsequent, discover the middle of the ribbon and place it on prime of the field. Carry the 2 ends of the ribbon collectively and cross them over one another. Then, convey the right-hand finish of the ribbon over the left-hand finish and thru the loop that you just created. Pull the ribbon tight to create a knot. Now, you possibly can tie a bow within the ribbon. To do that, convey the left-hand finish of the ribbon over the right-hand finish and thru the loop that you just created. Then, convey the right-hand finish of the ribbon over the left-hand finish and thru the loop that you just created. Pull the ribbon tight to create a bow. Lastly, trim the ends of the ribbon to the specified size.
Easy methods to Tie Ribbon on a Field
Supplies:
- Ribbon
- Scissors
Directions:
1. Lower a size of ribbon. Measure twice the peak of the field, plus the size you need for the bow. For the standard-sized field, 24 inches is an efficient place to begin.
2. Drape the ribbon excessive of the field, with the middle of the ribbon on the entrance.
3. Cross the left finish of the ribbon over the fitting finish, bringing it to the again of the field.
4. Carry the fitting finish of the ribbon up and thru the loop created by the left finish.
5. Tighten the knot by pulling on each ends of the ribbon.
6. Create a bow by forming a loop with one finish of the ribbon. Carry the opposite finish of the ribbon across the loop and thread it by the middle.
7. Tighten the bow and trim any extra ribbon.
Individuals Additionally Ask About Easy methods to Tie Ribbon On A Field
How do I tie a double bow on a field?
To tie a double bow:
- Observe the directions for tying a single bow.
- After tightening the primary bow, make a brand new loop with the left finish of the ribbon and produce it across the first bow.
- Thread the fitting finish of the ribbon by the middle of the brand new loop and tighten.
- Trim any extra ribbon.
How do I tie a ribbon on a field and not using a lid?
To tie a ribbon on a field and not using a lid:
- Lower a size of ribbon that’s twice the circumference of the field, plus the size you need for the bow.
- Wrap the ribbon across the field, crossing the ends on the prime.
- Tie a knot within the ends of the ribbon.
- Create a bow as desired.
How do I tie a ribbon on a spherical field?
To tie a ribbon on a spherical field:
- Lower a size of ribbon that’s twice the circumference of the field, plus the size you need for the bow.
- Heart the ribbon on the highest of the field.
- Cross the ends of the ribbon in the back of the field.
- Carry the fitting finish of the ribbon up and over the left finish, then down and thru the loop created by the left finish.
- Tighten the knot.
- Create a bow as desired.
